To Becker websiteUsage recommendation
- Lighting
- Roller shutter
Integration into Becker CentralControl possible
Two intermediate positions can be programmed
Blind mode: Two intermediate positions (with tilt) can be programmed
Blind mode: Exact adjustment of slat angle possible
Two memory switching times with daily repetition programmable
Compatible with the KNX-RF radio standard
The device feeds its position or switching state and status information back to the operator unit and gateway
An additional operator control can be connected
Optional potential-free switching contact
Can be fitted into any flush-mounted device socket with 58 mm diameter according to DIN EN 49073 / DIN EN 60670
Installation behind the operator control in any deep flush-mounted switch box possible
General product data
RRP (incl. VAT)
168,00 €
GTIN
4251852908624
Designation
B-Tronic VarioControl VC4200B
Series
Receiver
Item number
4035 000 009 0
Sales unit
pc.
Technical data
Type of mounting
Flush mounted
Pulse output
Ja
Length
49 mm
Touch mode
Can be integrated into the switch frame
no
Intermediate positions
2
Height/depth
28 mm
Weight
0.093 kg
IP degree of protection
20
Width
47 mm
Number of channels
1
Power supply (AC/DC)
Alternating current
Colour
Grey
Mains frequency
50/60 Hz
Dimensions
B x H x T: 47 x 49 x 28 mm
Repeater function
Switching current max.
µ 3A / 230V / AC cos Φ = 1
Rated voltage
110 - 240 V
Dimensional drawing
Communication
Bidirectional product
Additional features
Intermediate positions
2
Time function
Memory
Sensor functions
Sensor values - evaluable
- Wind
- Sun
Time function
Time function
Memory
Assembly and operating instructions
Declarations of conformity
Problem:
Drive is not functioning.
Remedy:
Drive is running in the wrong direction.
Remedy:
The radio receiver does not perform manual drive commands.
Remedy:
Drive is not functioning.
Remedy:
- Check the electrical connection.
____________________________________________
Drive is running in the wrong direction.
Remedy:
- Swap the drive wires for OPEN and CLOSE.
____________________________________________
The radio receiver does not perform manual drive commands.
Remedy:
- Program transmitter.
- Connect the external button correctly.
Problem:
The radio receiver does not perform automatic drive commands.
Remedy:
The radio receiver does not perform automatic drive commands.
Remedy:
- Program transmitter.
- Set the transmitter to automatic mode.
Intermediate positions 1 or 2 cannot be programmed.
Remedy:
Remedy:
- Perform the programming run in accordance with the instructions for the B-Tronic transmitter.
Programming failed.
Remedy:
Remedy:
- Set the same function at the transmitter and receiver.
The feedback is not plausible (function switch in position 1, 2, 8 or 9)
Remedy:
Remedy:
- Delete and restart the programming run in accordance with the instructions for the B-Tronic transmitter.
The feedback is not plausible (function switch in position 1 or 2)
Remedy:
Remedy:
- Reset the radio receiver back to the factory setting. Depending on the shading solution, set the function switch to position 8 or 9. Put the device back into operation.
The intermediate position/tilt position is not moved to correctly (function switch in position 8 or 9)
Remedy:
Remedy:
- Always move to the intermediate position/tilt position from the corresponding limit position.
____________________________________________