Usage recommendation
Roller shutter
Product highlights
Blind mode: Exact adjustment of slat angle possible
Emergency operation due to battery buffering possible
Defined drive commands possible
General product data
Designation
Escape door control unit HC520 2.600 mAH
Item number
4007 000 025 0
RRP (incl. VAT)
563,00 €
Series
Control units
GTIN
4251852917152
Sales unit
pc.
Technical data
Weight
2.5 kg
Dimensions
B x H x T: 25 x 50 x 52 mm
Mains frequency
50/60 Hz
Colour
Black
Height/depth
52 mm
Power supply (AC/DC)
Alternating current
Width
25 mm
Type of mounting
Flush mounted
IP degree of protection
20
Switching current max.
µ 5A / 230V / AC cos Φ = 1
Number of channels
1
Length
50 mm
Can be integrated into the switch frame
no
Rated voltage
110 - 240 V
Communication
Control modes
- Shutter/venetian blind
- Venetian blind
- Roller shutter
Assembly and operating instructions
Declarations of conformity
Miscellaneous
Problem:
Drive is not functioning.
Remedy:
- Check the electrical connection.
- Check position of safety switch.
Problem:
Drive is running in the wrong direction.
Remedy:
Swap the drive wires for OPEN and CLOSE.
Problem:
Control unit does not carry out the automatic opening movement.
Remedy:
Drive is running in the wrong direction.
Remedy:
Swap the drive wires for OPEN and CLOSE.
Problem:
Control unit does not carry out the automatic opening movement.
Remedy:
- Check DIP switch setting.
- Check connection.
- Check battery voltage.
- Have battery replaced by a qualified electrician.
Problem:
Drive does not reach the lower limit position.
Remedy:
Drive does not reach the lower limit position.
Remedy:
- Check system for an obstacle or sluggish running.
Problem:
Drive only runs in up direction.
Remedy:
Drive only runs in up direction.
Remedy:
- Check position of safety switch.
- Check battery voltage.
Problem:
Remedy:
Drive does not stop after detecting a blockage.
Remedy:
The drive does not carry out the drive command correctly.
Remedy:
- Check whether a switch has been used for individual operation instead of the stipulated push-button.
Drive does not stop after detecting a blockage.
Remedy:
- Check whether a switch has been used for individual operation instead of the stipulated push-button.
____________________________________________