To Becker websiteUsage recommendation
Roller shutter
Blind mode: Exact adjustment of slat angle possible
Emergency operation due to battery buffering possible
Defined drive commands possible
General product data
GTIN
4251852917152
Sales unit
pc.
Item number
4007 000 025 0
Designation
Escape door control unit HC520 2.600 mAH
RRP (incl. VAT)
563,00 €
Series
Control units
Technical data
Can be integrated into the switch frame
no
Weight
2.5 kg
Width
25 mm
Number of channels
1
Type of mounting
Flush mounted
Length
50 mm
Dimensions
B x H x T: 25 x 50 x 52 mm
Colour
Black
Power supply (AC/DC)
Alternating current
Switching current max.
µ 5A / 230V / AC cos Φ = 1
Height/depth
52 mm
IP degree of protection
20
Mains frequency
50/60 Hz
Rated voltage
110 - 240 V
Assembly and operating instructions
Declarations of conformity
Miscellaneous
Problem:
Drive is not functioning.
Remedy:
- Check the electrical connection.
- Check position of safety switch.
Problem:
Drive is running in the wrong direction.
Remedy:
Swap the drive wires for OPEN and CLOSE.
Problem:
Control unit does not carry out the automatic opening movement.
Remedy:
Drive is running in the wrong direction.
Remedy:
Swap the drive wires for OPEN and CLOSE.
Problem:
Control unit does not carry out the automatic opening movement.
Remedy:
- Check DIP switch setting.
- Check connection.
- Check battery voltage.
- Have battery replaced by a qualified electrician.
Problem:
Drive does not reach the lower limit position.
Remedy:
Drive does not reach the lower limit position.
Remedy:
- Check system for an obstacle or sluggish running.
Problem:
Drive only runs in up direction.
Remedy:
Drive only runs in up direction.
Remedy:
- Check position of safety switch.
- Check battery voltage.
Problem:
Remedy:
Drive does not stop after detecting a blockage.
Remedy:
The drive does not carry out the drive command correctly.
Remedy:
- Check whether a switch has been used for individual operation instead of the stipulated push-button.
Drive does not stop after detecting a blockage.
Remedy:
- Check whether a switch has been used for individual operation instead of the stipulated push-button.
____________________________________________