Usage recommendation
- Venetian blind/shutter
- Sun protection
Product highlights
Enables the programming of two intermediate positions
Single, group or central control unit
Channels can be controlled independently from one another
Setting the threshold values possible directly on the device
On/off switching and dimming of light sources
Integrated transmission pilot lights
Changing between manual and automatic mode possible on the operating device directly
Rear labelling field
Light button for additional on/off switching and dimming of lamps and lighting equipment (second channel)
Defined drive commands possible
General product data
GTIN
4251852908037
Sales unit
pc.
Series
Transmitter
RRP (incl. VAT)
224,00 €
Item number
4033 000 203 0
Designation
Centronic SunWindControl SWC442-II
Technical data
Mains frequency
0 Hz
Battery type
CR 2430
Can be integrated into the switch frame
no
Colour
White
Length
123 mm
Weight
0.138 kg
Touch mode
Wall bracket included
Dimensions
B x H x T: 39 x 123 x 21 mm
Width
39 mm
Number of channels
1
Power supply (AC/DC)
DC
Intermediate positions
Dependent upon receiver
Type of mounting
Hand-held device
Height/depth
21 mm
IP degree of protection
20
Rated voltage
3 V
Dimensional drawing
Additional features
Intermediate positions
Dependent upon receiver
Sensor functions
Manual/automatic mode changeover
Sensor values - threshold settings
- Sun
- Wind
Assembly and operating instructions
Declarations of conformity
Problem:
Drive is not functioning.
Remedy:
Automatic drive commands are not executed.
Remedy:
The lighting equipment goes on when the travel button is pressed.
Remedy:
Drive is not functioning.
Remedy:
- Insert new battery correctly.
- Reduce distance from receiver.
- Transmitter is not programmed into receiver. Program transmitter.
____________________________________________
Automatic drive commands are not executed.
Remedy:
- Set the slide switch to Automatic.
- Move the slide switch from SUN to MANUAL and then back to SUN.
____________________________________________
The lighting equipment goes on when the travel button is pressed.
Remedy:
- Assignment of transmitter and receiver is incorrect. Repeat the programming of the light function.
____________________________________________
This may also interest you!